Zipp Vuka Extensions

These extensions are both extremely light and extremely strong. Available in Straight, Ski Tip or Chicane (S-Bend) these extensions come in 335mm length, and can be cut down almost 100mm, to accommodate virtually any bike configuration, including ITU legal racing.

Designed to work well with either Vuka Aero or Vuka Clip, these extensions maximize your aero advantage by routing cables internally, and allowing virtually any hand position you could dream of.

Guidelines For Cutting The Extensions

The extensions are marked on the underside in 1cm increments with half centimeter increments shown with smaller lines. A minimum of 3cm of extension must be inserted into the VukaBullet body to avoid damaging the extensions. This means that a minimum of 6 marks (3 large and 3 small) must be inserted into the bar after the bars are cut to length.

If more than 4cm of extension need to be removed, we recommend removing in 2-3cm increments to avoid overcutting of the extensions. The extension should be wrapped in masking tape at the point where it will be cut and cut with a composite or FRP specific hacksaw blade. The masking tape will help ensure that the cut is clean and no jagged fibers lift off of the part.

Warning - do NOT cut anything from the front end of these extensions.